| ICOM
IC-M3A Specifications |
| This information is taken directly off of
the ICOM IC-M3A brochure.
|
| General |
- Usable channels: U.S.A., Canadian and
International, plus 10 Weather
- Mode: FM (16K0G3E)
- Current drain (at 7.2 V DC, negative
ground): 1.6 A (Tx at 5 W output), 0.7 A (Tx at 1 W output), 230 mA
(Rx on max. audio), 60 mA (Rx on standby, squelched), 20 mA (Rx on
power saved, average)
- Usable temperature range: -20°C to
+60°C; -4°F to +140°F
- Frequency stability (-20°C to +60°C):
+/-10 ppm
- Dimension (projections not included):
58(W) x 140.5(H) x 43.5(D) mm; 2-9/32(W) x 5-17/32(H) x 1-23/32(D) in
- Weight: 410 g; 14.4 oz.
|
| Transmitter |
- Output power (at 7.2 V DC ): 5 W high,
1 W low
- Modulation system: Variable reactance
modulation
- Spurious emissions: Less than -65 dB
- Maximum frequency deviation: +/-5.0
kHz
- Microphone impedance: 2 ohms
|
|
Receiver
|
- Receive system: Double conversion
superheterodyne
- Sensitivity: 0.25 µV typical (for 12
dB SINAD)
- Squelch sensitivity: 0.25 µV typical
- Intermodulation rejection: 70 dB
typical
- Adjacent channel selectivity: 70 dB
typical
- Spurious response rejection ratio:70
dB typical
- Audio output power: 500 mW typical at
10% distortion with an 8 load
- Audio output impedance: 8 ohms
|
| Options |
- BP-204 BATTERY CASE: Takes 6 R6(AA)
batteries. Both alkaline or Ni-Cd batteries can be used. The same as
supplied.
- CP-12L CIGARETTE LIGHTER CABLE WITH
NOISE FILTER
- OPC-254L DC POWER CABLE: Allows you to
charge the transceiver through a 12 V cigarette lighter socket with
the CP-12L or OPC-254L, respectively
- BC-131A WALL CHARGER: Regularly
charges Ni-Cd batteries in the BP-204. The same as supplied with the
USA version
- FASC-54V ANTENNA: for 146-174 MHz
- NC-M3NYLON CARRYING CASE: For IC-M3A
- SP-13EARPHONE
- 96911576RAIN PLUG: For IC-M3A-SM
- MB-68/V BELT CLIP: Same as supplied
- SPEAKER MIC VERSION ONLY (IC-M3ASM)
- HM-46 SPEAKER MIC: Slim line
- HM-54 SPEAKER MIC: Commercial grade
- HS-10 HEADSET: With boom mic (needs
either HS-10SA or HS-10SB)
- HS-10SA VOX: For use with HS-10
- HS-10SB PTT SWITCHBOX; For use with
HS-10
- HS-51HEADSET; With built-in PTT and
VOX operation
|
| Supplied
Accessories |
- Battery case
- Ni-Cd cells
- Wall charger
- Antenna
- Hand strap
- Belt clip
- Operating manual
|
