|
| |
 
| IC-M710RT
Specifications |
| This information is taken directly off of
the ICOM IC-M710RT brochure.
|
| General |
- Frequency Coverage (MHz):
- Receive: 0.5 - 29.9999
- Transmit: 1.6 - 27.5 MHz,
Restrictions may apply depending on version.
- Mode (varies with version): J3E (USB),
H3E, J2B (AFSK), F1B (FSK), R3E, A1A (CW)
- Antenna Connector: SO-239 (50 )
- Power Supply Requirement: 13.6 V DC
+/-15% (negative ground)
- Max. Current Drain (at 13.8 V DC):
- Main Unit: 30 A (Transmit at max
power)
- Controller: 1.2 A (Receive at max
power)
- Usable Temperature Range: -30°C to
+60°C (-22°F to +140°F)
- Frequency Stability: (-20°C to +60°C)
- 0.5 - 14.9999 MHz: +/-10 Hz
- 15 - 29.9999 MHz +/-20 Hz (GMDSS
+/-10 Hz)
- Remote Connector: RS-232C D-Sub 9-pin
(female)
- Dimensions (projections not included):
- Main Unit: 292(W) x 117(H) x
317(D) mm; 11.5(W) x 4.6(H) x 12.5(D) in
- Remote Controller: 292(W) x 116(H)
x 66(D) mm; 11.5(W) x 4.6(H) x 2.5(D) in
- Weight:
- Main Unit: 7.45 kg; 16 lb, 7 oz.
For GMDSS version, 7.65 kg; 16 lb, 14 oz
- Remote Controller: 1.2 kg; 2 lb,
10 oz
|
| Transmitter |
- Output Power:
- Below 25 MHz: 150/60/20 W PEP.
Does not apply to Europe version. GMDSS 125 W PEP only*.
- Above 25 MHz: 60/20 W PEP. Does
not apply to Europe version. GMDSS 85 W PEP only*.
- *Output power for GMDSS versions
is provided by the AT-130/E antenna tuner
- Spurious Emissions: -65 dB (USA), -60
dB (Europe)
- Carrier Suppression: 40 dB
- Unwanted Sideband Suppression: 55 dB
- Microphone Impedance: 600 ohm
|
| Receiver |
- Sensitivity J3E, R3E, J2B, F1B, A1A
(for 12 dB SINAD):
- 0.5 µV (1.8-29.9999 MHz)
- 1 µV (1.6-1.7999 MHz)
- 6.3 µV (0.5-1.5999 MHz)
- Sensitivity H3E (10 dB S/N):
- 3.2 µV (1.8-29.9999 MHz)
- 6.3 µV (1.6-1.7999 MHz)
- 32 µV (0.5-1.5999 MHz)
- Spurious Response Rejection Ratio:
More than 70 dB (1.6-29.9999 MHz)
- Audio Output Power (at 13.6 V): 4.5 W
typical at 10% distortion with a 4 ohm load
- Audio Output Impedance: 4 - 8 ohms
- Clarity Variable Range: +/-150 Hz
|
| Supplied
Accessories |
- Hand Microphone/Handset (depending on
version)
- 2 Mounting Bracket Kits - one for
Controller, one for Main Unit
- ACC Plugs
- Microphone Hanger
- Spare Fuses
- DC Power Cables - for Controller and
Main Unit
- Separation Cable (5 m; 16.4 ft)
|
| Options |
- GM-110DSC DSC TERMINAL UNIT: 6 channel
emergency scanning receiver - contains remote control capability of
the IC-M710RT GMDSS for distress calls, etc.
- AT-130/E HF AUTOMATIC ANTENNA TUNER:
Matches the transceiver to a long wire antenna with little insertion
loss.
- MN-100 ANTENNA MATCHER: Match the
transceiver to a dipole antenna. Covers all HF bands from 1.5 to 30
MHz. 8 m x 2 antenna wires comes attached.
- MN-100L ANTENNA MATCHER: Match the
transceiver to a dipole antenna. Covers all HF bands from 1.5 to 30
MHz. 15 m x 1 antenna wire comes attached.
- AH-710 FOLDED DIPOLE ANTENNA: Covers
from 1.9 to 30 MHz band. Has an SO-239 connector. Easy to assemble
(non-kink construction).
- UT-95 2-TONE ALARM UNIT: Provides the
alarm function. Already built in to the marine version.
- PS-60 DC POWER SUPPLY: Provides 13.6 V
DC (30 A) output from an AC outlet.
- PS-66 DC-DC CONVERTER: Provides 13.6 V
DC (30 A) output from 19-32 V DC.
- HS-50 HANDSET: Provides clear audio
reception and listening privacy.
- HM-120 HAND MICROPHONE: Same as
supplied with some versions of the IC-M710RT.
- FL-100 CW/FSK NARROW FILTER (500 Hz/-6
dB): Has good shape factor to provide better CW/RTTY reception. A 350
Hz/-6 dB Narrow Filter is already built-in to the GMDSS versions.
- RC-21 REMOTE CONTROLLER: Additional
controller unit allows intercom function. The HM-120 or the HS-50 is
supplied, depending on version.
- OPC-772 SEPARATION CABLE: For extended
use. Cable length 20 M (67.4 ft). 5 M cable (16.4 ft) OPC-771 is also
available.
- RS-M710RT REMOTE CONTROL SOFTWARE:
Controls the IC-M710RT from your PC. Ask your dealer about usable PCs.
- MB-70 FLUSH MOUNT KIT: For mounting a
controller or the RC-21 to a panel.
|
| |
|
